This Is The Forming Process Of Marble Stone

Marble is the result of metamorphosis from limestone or often called limestone. This limestone undergoes recrystallization, which eventually will turn into marble. Marble stone is the result of the metamorphosis of limestone or limestone or dolomite. This metamorphosis begins with the recrystallization process in the limestone. This recrystallization process re-occurs due to the influence of temperature and also the pressure generated by the endogenous force. This recrystallization process forms a variety of foliation and non-foliation. In the meantime, if you’re interested in marble furniture, perhaps you need to check out the best Marble Vanity Top Singapore.

Then, the recrystallization process in limestone results in the loss of the original structure of the rock, thus forming a new texture and also the regularity of the grains. The new texture and regularity of this grain are known as marble. This geological process took about 30 to 60 million years ago.

Those are the two short processes of forming marble from limestone. Marble will always be associated with limestone. Every time there is marble, there will always be limestone, but every time there is limestone there is not always marble. This is because the existence of marble is closely related to the endogenous force processes that affect it, both in the form of high pressure and temperature changes. This process takes years and not a short time. To be clearer, the process of the occurrence of marble can be visualized in the picture on the side.

Marble is widely used in the building construction industry or architecture. This marble processing activity is the processing of marble blocks that have been produced into final finished goods and ready to be heated. Some of the main core processing of marble stones are as follows:

Marble in the form of blocks with a size of about 260x110x135 cm sawed into several slabs with an average thickness of 2 cm.

Then the marble slab is cut into half-finished items according to the desired size.

The semi-finished goods are then ground in two stages, then refined or patched with holes.

Then after grinding two stages, refined and ground again four stages, polished until shiny.

Leave a Reply

Your email address will not be published. Required fields are marked *